Caribbean Hurricane Shutters

Repair & Maintenance

Trusted storm protection across the USVI, BVI, Puerto Rico and the Leeward Islands.

Service & repair

Repair, maintenance and emergency shutter service

Storm protection does not end at installation day. We service what we install β€” and most other major systems β€” with track, hardware and extrusion inventory staged on-island.

24/7 storm hotline β€” (340) 555-0142

What we repair

  • Jammed or binding accordion tracks
  • Rolldown motor and remote replacement
  • Seized bearings, rollers and carriers
  • Corroded fastener and hardware swap-out
  • Bahama prop-arm and hinge repair
  • Replacement panels, tracks and wingnuts
  • Post-storm damage assessment reports
  • Annual pre-season inspection visits

Maintenance guide

Rinse quarterly

Fresh water on tracks and hardware clears salt build-up. Salt, not wind, is what kills shutter hardware in the islands.

Lubricate with dry silicone

Dry silicone spray on tracks, carriers and locks twice a year. Never use grease or oil β€” both hold sand and grit.

Cycle every system twice a year

Open and close everything before the season and again mid-season. A shutter that has not moved in two years is the one that jams.

Check anchors after every event

Look for elongated holes, rust weep and loose fasteners around the anchoring points. Those are the first sign of load transfer problems.

Adding new openings instead?

Compare shutter systems

Reviews

Trusted across the islands

β˜…β˜…β˜…β˜…β˜…

“They surveyed the villa on a Tuesday and had every opening covered before the next system formed. Clean tracks, straight lines, no drama.”

Dana R.
St. Thomas, USVI
β˜…β˜…β˜…β˜…β˜…

“We put motorized rolldowns on the whole rental. One switch closes the property when we are off-island β€” worth every dollar.”

Marcus L.
Tortola, BVI
β˜…β˜…β˜…β˜…β˜…

“Third company we called and the only one who explained design pressure. Our insurer applied the wind mitigation credit right away.”

Ivette S.
Fajardo, PR
β˜…β˜…β˜…β˜…β˜…

“Had an issue with the finish a year later and they replaced the shutter without an argument. That is rare anywhere, let alone down here.”

Peter H.
St. John, USVI
β˜…β˜…β˜…β˜…β˜…

“They walked our condo board through the whole approval packet. The association signed off on the first submission.”

Alicia M.
San Juan, PR
β˜…β˜…β˜…β˜…β˜…

“Kevlar screens across the full veranda five years ago. Two hurricanes later they still run smooth and the porch is intact.”

Ken W.
St. Croix, USVI
FAQ

Common questions

What are hurricane shutters and how do they work?

Hurricane shutters are impact-rated systems β€” panels, folding tracks or rolldown slats β€” that cover windows, doors and other openings before a storm. When deployed they stop wind-driven debris from breaching the building envelope. If a single opening fails during a storm, internal pressure spikes and the roof is next. Shutters are what prevents that.

Which hurricane shutters are best for a Caribbean home?

It depends on the building and how you use it. For full-time residents accordion shutters are the best balance of protection, ease of use and cost. For owners who are off-island when a storm forms, motorized rolldowns are the gold standard. Where an association controls appearance, Bahama or colonial systems usually satisfy both the board and the code.

How much do hurricane shutters cost?

Aluminum storm panels start at $18 per square foot installed and clear panels at $26. Accordion shutters run from $38, Bahama from $44, colonial from $46 and rolldowns from $52 per square foot, with electric motors adding about $700 per opening. A full home usually lands between $8,000 and $25,000 depending on the system and opening count.

Do you handle permits and association approvals?

Yes. Permits, product approval documentation, architectural modification requests and insurance wind-mitigation forms are all part of the job. Most clients never speak to a building department or board directly.

Will hurricane shutters lower my insurance premium?

In most cases. Carriers writing in the islands offer wind-mitigation credits for impact-rated, professionally installed shutters. We provide the Design Pressure analysis and product approvals your insurer needs.

How long does installation take?

Fabrication runs three to five weeks after final measurement. Installation is typically one to three days for a house, and we schedule larger commercial and resort projects in phases.

What is Design Pressure analysis and why does it matter?

It is a site-specific calculation of the maximum wind load your openings will see, based on exposure, height, opening size and building geometry. It determines the system rating and the exact fastener pattern. Without it, a shutter is rated generically and the anchors are a guess.

Do you service shutters you did not install?

Yes. We repair, re-track, re-tension and replace hardware on most major systems, and we carry track and extrusion inventory on-island so repairs are not a six-week wait.

Ready to protect your home?

Get a written, itemized estimate before the next storm season starts.

Get a Free Estimate Call (340) 555-0142
Service Areas

Where we work

U.S. Virgin Islands

Our home base. Crews, fabrication and hardware inventory are staged in Charlotte Amalie, so USVI estimates are usually scheduled the same week.

  • St. ThomasHillside exposure and steep driveways β€” we survey access before scheduling lifts.
  • St. JohnBarge scheduling included in every quote; no surprise freight line items.
  • St. CroixMasonry-heavy construction; we anchor into block with sleeve fasteners rated to your DP.
  • Water IslandSmall-boat access projects handled with pre-fabricated, pre-labeled assemblies.

British Virgin Islands

Weekly crew rotations to Tortola and Virgin Gorda, with customs paperwork prepared before the material leaves the shop.

  • TortolaVilla and marina-front projects with full permit handling.
  • Virgin GordaRemote-site installs planned around ferry and barge windows.
  • Jost Van DykeSmall commercial and guesthouse packages.
  • AnegadaLow-lying exposure β€” screens and rated panels on the windward side.

Puerto Rico

Island-wide coverage from San Juan to RincΓ³n, including condo boards and multi-building HOA portfolios.

  • San JuanHigh-rise condo work with association documentation included.
  • FajardoMarina and east-coast exposure; motorized rolldowns most requested.
  • RincΓ³nWest-coast surf-belt homes with heavy salt cycling.
  • CulebraFerry-scheduled installs with pre-cut, pre-labeled material.
  • ViequesOff-grid and solar properties with battery-backed motor systems.

Leeward Islands

Resort, villa and multi-building projects across the northern Leewards, scheduled as travel packages.

  • St. MaartenDual-jurisdiction permitting handled on both sides of the island.
  • AnguillaResort and villa portfolios with phased installation.
  • St. KittsHillside villas and commercial storefront security shutters.
  • AntiguaYacht-club and marina commercial packages.
Install crew fitting hurricane shutters
Why homeowners choose us

Licensed, insured, and on the island year-round

  • Licensed general contractor USVI & PR
  • OSHA-30 certified install crews
  • 7-year workmanship warranty
  • $2M liability insurance